O W N E R ' S M A N U A L • R 2 5
rate, press RECOVERY. The display also shows the word ”Recovery”.
2.The measuring starts automatically and takes two minutes.
3.Upon completion of the measurement,
the display shows the recovery rate as a percentage. The smaller the rate, the fitter you are. Please note that your results are in a relation to the pulse level in the beginning of the measurement, and that your results are personal and cannot directly be compared with any other person’s results. In order to improve the reliability of recovery pulse measurement, always try to standardize the measurement situation as accurately as possible; start measuring at the same heart rate level as precisely as possible.
4.To switch back to the main display by pressing RESET. The console will also automatically switch to the main display one minute after the completion of the measurement.
TRANSPORT AND STORAGE
Move the device according to the following instruction, because lifting the rower incorrectly may strain your back or cause other risk of accidents:
Stand behind the device and grip the rail with one hand and the seat with the other. Tilt the device so that is rests on the transportation wheels. Move the device by wheeling it on transportation wheels. Lower the device onto floor while holding on to the rail and the seat,all the time remaining behind the device.
Transport the equipment with caution over uneven surfaces, for example over a step. The equipment should never be transported upstairs using the wheels over the steps, instead it must be carried. We recommend that you use a protective base when transporting the equipment.
To prevent malfunctioning of the rower, store in a dry place with as little temperature variation as possible, protected from dust.
MAINTENANCE
•The R25 requires very little maintenance. Check, however, from time to time that all screws and nuts are tight.
•Clean the rower with a damp cloth. Do not use solvents.
•Never remove the protective covers.
•Clean the inner surfaces of the rail if necessary so that the seat moves as smoothly and quietly as possible.
CHANGING BATTERIES
The console gives a warning signal before the change of batteries is due. Remove the battery compartment cover from the back side of the meter and remove old batteries. Place new batteries in the holder (note the direction of the batteries) and reattach the cover. To minimize the strain on the resistance mechanism, we recommend that the resistance adjustment knob is set to position 1 after every training session.
MALFUNCTIONS
Despite continuous quality control, defects and malfunctions caused by individual components may occur in the equipment. In most cases it’s unnecessary to take the whole device in for repair, as it’s usually sufficient to replace the defective part. If the equipment does not function properly during use, contact your Tunturi dealer immediately. Always give the model and serial number of your equipment. Please state also the nature of the problem, conditions of use and purchase date.
If you require spare parts, always give the model, serial number of your equipment and the spare part number for the part you need. The spare part list is at the back of this manual. Use only spare parts mentioned in the spare part list.
TECHNICAL SPECIFICATIONS
Length (folded) | 201 | (94) cm |
Width (folded) | 53 | (53) cm |
Height (folded) | 65 (124) cm | |
Weight | 31,6 kg | |
The R25 meets EN precision and safety standards
Due to our continuous policy of product development, Tunturi reserves the right to change specifications without notice.
NOTE! The instructions must be followed carefully in the assembly, use and maintenance of your equipment. The warranty does not cover damage due to negligence of the assembly, adjustment and maintenance instructions described herein. Changes or modifications not expressly approved by Tunturi will void the user's authority to operate the equipment!
We wish you many enjoyable trainings with your new Tunturi training partner!
6
