user manual
TCS series
Rigging the TCS-40 with 3-wide TCS-56/59 arrays
Parts required: 3 x TCS-56 or TCS-59 enclosures
1x TCS-40 enclosure
1x TP-55/3 flying assembly top plate
1x SB-40 swivel bracket
4x M10 x 36mm shoulder eyebolts
6x M10 x 36mm hex head bolts
8x flat washers
8x spring washers
2x No.6 x 1” woodscrews
1.Assemble the array as described in steps 1 to 5 on the previous page.
2.Invert the array and attach the SB-40 bracket to the bottom of the cabinets by removing the countersink screws and replacing them with M10 x 36mm hex head bolts.
3.Attach the TCS-40 enclosure using M10 x 36mm hex head bolts. The enclosure is designed with a 15° top panel angle to allow it to be positioned close to the TCS- 56/59 enclosures and angled downwards. Further adjustment to the desired downward angle can then be made. Use the small holes in the ends of the SB-40 swivel bracket to lock the cabinet at the required angle using the No.6 woodscrews.
4.Tighten all hardware and prepare to lift the array into position.
Attach safety chains to the holes provided at the rear of the flying assembly top plates.
