Turning Technologies 1850, 2850 manual Remove the expansion-card riser board

c o m

Figure 1-4. Removing the Expansion-Card Riser Board From a Dell PowerEdge 2850 System

w w w . d e l l . c o m s u p p o r t . d e l l .

slots

tabs

RAID memory module connector

RAID battery connector

expansion-card guide

expansion-card guide release tabs (2)

expansion-card riser board

retention pin

expansion card openings

3Remove the expansion-card riser board:

a Pull the riser retention pin. See Figure 1-4.

b While pulling the retention pin, slide the riser board away from the expansion card openings.

c Lift the expansion-card riser board from the six securing tabs.

4Place the riser board in the expansion-card cage so that the tabs are fully inserted in the slots on the riser board. See Figure 1-4.

5Slide the riser board toward the expansion card openings until you feel the riser-board retention pin snap into place.

6Close the expansion-card guide.

7If applicable, reinstall the RAID memory module onto the riser board.

10

Upgrading Your System Board and Riser Board