Installing the New System Board and Riser Board
1Unpack the new system board.
2Carefully lower the system board into the chassis until the tabs on the chassis fit through the corresponding slots in the system board.
3Slide the system board towards the back of the chassis until the retention pin engages.
4Replace the
a Place the
b Slide the
5Replace the front fans.
6Raise the
7Replace the memory modules.
8Replace the memory module cover.
9Replace the processor(s).
10If applicable, replace the RAC card.
11If applicable, replace the RAID key.
12Replace the
13Replace the power supply(s).
14Replace the riser board in the
15Reinstall the
16If applicable, reconnect the RAID battery cable to the riser board. See Figure
17Reinstall the cover.
18If applicable, reattach the bezel.
Upgrading the Dell PowerEdge 2850 Expansion-Card Riser Board
1If applicable, remove the RAID memory module from the
2Press both release tabs on the
Upgrading Your System Board and Riser Board
9