X4 Transmitter

IN

DIGITAL

OUT

L

LINE IN

R

LINE IN

VOLUME

DC IN 9V

+

-

POWER

REAR VIEW

DIGITAL

INPUT

PL II

D

BYPASS

FRONT VIEW

Power Switch: Push to turn on the transmitter power. When the unit is powered on, the front panel power light (6) will be on.

NOTE: Switching the power button on and off repeatedly may cause the transmitter to not power up correctly. If this happens, turn off the transmitter power, wait a few seconds, then turn it on again so that it may reset properly.

Power Socket: Insert the included X4 power adapter into this socket.

CAUTION: Use only the supplied power adapter. Failure to use the correct adapter can result in fire, damage to the unit or other hazards.

Line In (stereo analog inputs): Use these inputs to connect analog audio sources, such as a TV, MP3 Player, etc . If the Bypass (10) is turned off, the analog stereo signal will be processed by the Dolby Pro Logic II decoder, producing an expanded stereo effect.

Volume control: Sets the sensitivity of the analog inputs to accept a wide range of input levels. This control has no effect on the digital input signal level. Typically, this should be set to maximum and the headphone volume sholuld be used to adjust the listening level. If the sound distorts, turn down the transmitter volume control (4) to prevent overloading the analog inputs.

Digital Input and Output: Connect the X4 digital input (top) to the XBOX 360 digital output using the included fiber optic cable. The X4 digital input (top) is passed through to the X4 digital output (bottom) so you can simultaneously connect the X4 transmitter and your home theater system to hear the Xbox on the headphones and speakers at the same time. When the Xbox digital signal is active, the X4 transmitter’s analog inputs are disabled.

Power Indicator: Lights when the unit is powered on.

Digital Input Indicator: Lights when a digital signal is detected on the digital input.

IR Emitters: The IR emitters are located in this area and should remain free of any obstructions that may block the IR light beam from reaching the headphones.

Dolby Processing Indicators: The

 

PL II indicator will light whenever the digital or

 

analog input is being processed by the Dolby Pro Logic II decoder. The

 

 

D indicator will

 

 

light whenever the digital input signal is being processed by the Dolby Digital 5.1 surround sound decoder. Both indicators will turn off when the Bypass is ON.

Bypass Button and Indicator: Pressing this button turns off the Dolby processing, allowing you to hear the unmodified input signal. The light will turn on to indicate that Bypass is active and Dolby Processing is disabled.

Ear Force X4 Operating Instructions. Version 1.0 Copyright 2008 Voyetra Turtle Beach, Inc. All Rights Reserved

Page 3