Turtle Beach X4 X4 Headphones, LEFT, RIGHT, EAR CUP, EAR CUP, MICROPHONE

X4 Headphones

ON - BASS BOOST - OFF

POWER

Power Switch: Push to turn on the headphones. Push again to turn off. When power is on, the power light (5) flashes about once per second.

Automatic Power Shut-off Feature: If there is no sound transmitted for more than a few minutes, or if the headphones are outside of the transmitter’s range, the power light (5) will flash faster to indicate that the

LEFTEAR CUPMICROPHONE

Remove the foam cover and insert the mic boom so the holes in the mic casing are facing your mouth.

Then replace the foam cover.

RIGHT

EAR CUP

Insert both AAA

batteries with

the positive side

facing down

To remove the battery cover, push in here and slide down

Markers on the jack

indicate the proper position

when the foam cover

is on the mic

+AAABATTERY-

headphones are about to shut off. If the sound or transmitter signal do not return within approximately two minutes, the headphone power will shut off to conserve battery power.

XBOX Controller Jack: Insert the small connector at the end of the Xbox controller cable (see below) here.

Bass Boost Switch: Slide into the “ON” position to boost the bass frequencies in the game audio.

Game Volume: Turn to adjust the game sound level. The Xbox Live chat volume may be independently set by the volume control on the Xbox controller cable puck.

Power Light: Flashes about once per second when power is on. Flashes faster when power is about to be turned off automatically, as described above. Stops flashing and stays lit when the batteries are critically low and should be replaced.

Microphone socket: Insert the removable mic boom here. The socket is notched to prevent the boom from rotating after insertion.

To properly position the mic, remove the foam cover, insert the boom into the socket (6) so the holes on the mic casing (7) are facing your mouth. Then replace the foam cover. The boom jack also has a marker to indicate the proper mic position.

Installing Batteries: The headphones are powered by 2 AAA batteries located in the right ear cup. Push in and pull down on the lid to remove. Then insert both batteries with the positive sides facing down.

Page 5