Tyan Computer S2877 warranty Finishing Up, Applying power to the board

4

1

8	EPS 12V 8-pin (CPU Power)
	4	GND	8	+12V3
	3	GND	7	+12V3
	2	GND	6	+12V3
5	1	GND	5	+12V3

Applying power to the board

1.Connect the EPS 12V 8-pin power connector.

2.Connect the EPS 12V 24-pin power connector.

3.Connect power cable to power supply and power outlet

NOTE

YOU MUST unplug the power supply from the wall outlet before plugging the power cables to motherboard connectors.

2.16 – Finishing Up

Congratulations on making it this far! You’re finished setting up the hardware aspect of your computer. Before closing up your chassis, make sure that all cables and wires are connected properly, especially IDE cables and most importantly, jumpers. You may have difficulty powering on your system if the motherboard jumpers are not set correctly.

In the rare circumstance that you have experienced difficulty, you can find help by asking your vendor for assistance. If they are not available for assistance, please find setup information and documentation online at our website or by calling your vendor’s support line.

37

http://www.tyan.com