Tyco QuickStatTM Installation, Thermostat Controls and Display Symbols, Wiring the thermostat

2

QuickStat Installation & Operation Manual

Installation

Important: This thermostat must be installed according to all national and local electrical codes. The installation must be performed by quali- fied personnel.

Locating the floor temperature sensor

The floor temperature sensor is installed under the floor surface. See the QuickNet System Installation Manual (H57704), Section 6, for more details.

If required, the sensor cable can be extended to about 300 ft (91 m).

Wiring the thermostat

WARNING: TURN OFF THE POWER TO THE CIRCUIT AT THE MAIN POWER PANEL TO AVOID ELECTRIC SHOCK.

WARNING: SHOCK HAZARD. TO PREVENT SHOCK, THE QUICKNET FLOOR WARMING MAT MUST BE CONNECTED TO GROUND.

1.Connect power to the thermostat’s line terminals marked “L1 (L)” and “L2 (N)”.

2.Connect the floor warming cold lead to the load terminals marked “Load 16A Max”.

3.Connect the floor warming cold lead braid (ground) to the supply ground in the electrical junction box.

Mounting the thermostat in the electrical box

1. Use a screwdriver to remove the cover.

2. Mount the thermostat in the wall socket and re-attached the cover.

Thermostat Controls and Display Symbols

The following figure shows the thermostat controls:

QuickStat®

GFCI Class A

LINE L1 (L)

240/(120)VAC

	L2 (N)
LOAD
SENSOR	Max.
	16A

Line (black)

Line 2 (red) or Neutral (white)

Cold lead

Cold lead

1/4" (6 mm) Strip length

Supply ground

Reset button		Adjustment up
	Reset
Red light indicating		OK - accept
ground-fault	GFCI
	Test
		R
Test button		Adjustment down
Pin button for		Reset button for
adjusting clock		factory settings
		Digital
		display

The following figure shows the symbols that appear in the display window while you are programming:

4.Connect the floor temperature sensor to the screw-less terminals marked “Sensor”. Push on the terminal spring with a screwdriver and

insert the wires.

Wire nut Cold lead ground

	)		AC
	(L
E	L1		0)V
		2	)
LIN	40/(1		(N
	2	L2

	(16A)				D		A .
	(16A)			LO			M
Hz			1920W/2120VAC				S
	50/60		VOLTAGE3840W/240VAC		ROS
servicing						NE
Disconnect
		before		DUAL
			-supply
			NVoltagepower
			:
			IOT	UAHigh
				C

Clock function

Manual mode

Time and temperature

4-event symbol:

Wake

Night

Out

Home

%switch-on time Heating on

Day number