MM23016, Rev. C

27

7.13 DUAL-TONE MULTI-FREQUENCY

Dual-Tone Multi-Frequency (DTMF) is the system used by touch-tone telephones. DTMF assigns a
specific tone frequency to each key so a microprocessor can easily identify its activation. The radio
supports DTMF with a system model control head (Figure 7-1). This allows for specific tasks such as
entering a user ID and password, or selective calling.
When a key on the DTMF keypad is pressed, the DTMF tone is played through the radio’s speaker.

7.14 KEYPAD COMMANDS (SYSTEM MODEL CONTROL HEAD)

To perform a command from the key pad, press the * key followed by one of the pre-set function keys as
follows:
Table 7-5: Keypad Function Commands
*0 Log off command: *0## (logs the user off the system). See page 21 for additional information.
*1 Login command: *1<User ID> # <Password> ## (required for encryption). See page 20 for
additional information.
*4
Enter Scene of Incident Mode (SOI) on specified channel: *4<LC>#<Band># where LC is the
channel number that is being used as a SOI repeater and band is the number assigned to each
frequency band. For example, if LC 25 800 MHz (band 0) is being used for SOI, then enter
*4,25,#,0,#.
*4# Exit SOI Mode with.
*6 Go to default profile: Selects default profile if the radio is not voice registered.
*7 Initiate Selective Alert command: *7<Target ID>#[Choose Message]#. See page 36 for
additional information.
*8 Radio-to-Radio Call command: Selective call number # (PTT to dial).
*9 Public Switched Telephone Network (PSTN) Call command: See page 37 for additional
information.
*32 Begin Manual Encryption command: *32<Pre-Determined Encryption Key >#
1 – 16 digit encryption key for 128 bit encryption; 17 – 32 digit encryption key for 256 bit
encryption. See page 41 for additional information.
*33 End Manual Encryption command.

7.14.1 Password Entry

Password entry requires a system model control head. Password characters are encrypted on the display
using symbols to indicate the entry. The encryption symbols for each entry will appear in the display as
they are scrolled through, for example: '-' and '+'. Press the # key twice to complete the entry process.
If the password is wrong, the radio will not successfully register with the network for
wide area voice reception. The radio can still be used in single-site mode.