Manuals / Brands / Portable Media / Portable Radio / Tyco Electronics / Portable Media / Portable Radio

Tyco Electronics P5200, P7200 MM23772, Rev. F , 11.1.1 Buttons and Knobs

1 122

Download 122 pages, 3.18 Mb

MM23772, Rev. F

105

11.1.1 Buttons and Knobs

This section describes the primary function of the button and knob controls. Other functions associated

with these controls are detailed in later sections.

POWER ON/OFF

VOLUME KNOB Applies power to and adjusts the receiver’s volume. Rotating the control

clockwise applies power to the radio. A single alert tone (if enabled through

programming) indicates the radio is operational.

Rotating the control clockwise increases the volume level. Minimum volume

levels may be programmed into the radio to prevent missed calls due to a low

volume setting. While adjusting the volume, the display will momentarily

indicate the volume level (i.e. VOL=40). The volume range is from a minimum

programmed level of zero (displayed as OFF in the display) up to 40, which is the

loudest level.

SYSTEM/CHANNEL

SELECTION KNOB

Selects systems or channels (depending on programming). This is a 16-position

rotary knob.

Note: A mechanical stop, which can limit the positions accessed, is shipped with

the radio but must be installed. To install the mechanical stop, remove the

channel knob, loosen the set screw on the channel knob metal base (using a

1.27mm hex wrench), and remove the channel knob metal base. Replace the 16

channel ring with the channel stop ring located at the desired channel. Reinstall

the channel knob metal base, tighten the set screw, and reinstall the channel

knob.

EMERGENCY/

HOME BUTTON

Automatically selects the pre-programmed System by pressing and holding for a

programmed duration. It can also be used to declare an emergency by pressing

and holding for a programmed duration. The button must be pre-programmed for

either operation, but not both.

PTT BUTTON Push-To-Talk must be pressed before voice transmission begins.

SIDE OPTION

BUTTON 2 

Unsquelches the receiver and allows channel monitoring prior to transmission.

Momentarily removes the Channel Guard decoding from the channel.

SIDE OPTION

BUTTON 1 

Activates one of a number of programmable software options selected during PC

programming. Programmable options include hi/low power settings, keypad lock,

LCD contrast, LCD and keypad back lighting.

Contents

Main MM23772, Rev. F Page Page Page Page Page Page Page 1 SAFETY CONVENTIONS MM23772, Rev. F 2 SAFETY TRAINING INFORMATION 2.1 RF EXPOSURE GUIDELINES MM23772, Rev. F 2.2 ELECTROMAGNETIC INTERFERENCE/COMPATIBILITY MM23772, Rev. F 3 OPERATING TIPS 3.1 EFFICIENT RADIO OPERATION 3.1.1 Antenna Care and Replacement 3.1.2 Electronic Devices MM23772, Rev. F 3.1.3 Aircraft 3.1.4 Electric Blasting Caps 3.1.5 Potentially Explosive Atmospheres MM23772, Rev. F 4 BATTERIES 4.1 CONDITIONING BATTERY PACKS 4.1.1 Conditioning NiMH Battery Packs 4.1.2 Conditioning NiCD Battery Packs 4.1.3 Additional Information 4.2 CHARGING BATTERY PACKS 4.3 BATTERY PACK USAGE MM23772, Rev. F 4.4 CHANGE THE BATTERY PACK 4.4.1 Remove the Battery Pack 4.4.2 Attach the Battery Pack 4.5 BATTERY DISPOSAL MM23772, Rev. F 5 INTRODUCTION Page Page 6 OPTIONS AND ACCESSORIES MM23772, Rev. F 23 DESCRIPTION PART NUMBER 7 CHANGE OPERATING MODE MM23772, Rev. F 8 OPENSKY OPERATION 8.1 POWER ON/OFF AND VOLUME CONTROL 8.1.1 Power ON/OFF 8.1.2 Volume Control 8.2 CONTROLS MM23772, Rev. F 8.2.1 Buttons and Knobs Page 8.3 DISPLAY 8.4 RADIO STATUS ICONS 8.5 TRI-COLOR LED 8.6 LOG IN TO THE NETWORK MM23772, Rev. F 8.7 LOG OFF THE NETWORK 8.8 PERSONALITY 8.8.1 Profiles 8.8.2 Talk Groups MM23772, Rev. F 8.9 OPENSKY DISPLAY OVERVIEW 8.9.1 Displays Top Line 8.9.2 Displays Second Line 8.9.3 Dwell Display 8.10 ALERT TONES 8.11 BASIC MENU STRUCTURE Page 8.12 ERROR MESSAGES PLS LOGIN MM23772, Rev. F 37 8.13 KEYPAD 8.13.1 Keypad Function Commands (P7270 Only) MM23772, Rev. F 38 8.13.2 Quick Buttons (P7270 Only) 8.13.3 LOCK/UNLOCK the KEYPAD 8.13.4 Dual-Tone Multi-Frequency (P7270 only) Page Page MM23772, Rev. F 8.20.2 Transmit a Voice Call 8.21 ADJUST AUDIO TREBLE LEVEL 8.22 TALK GROUP LOCK OUT Page MM23772, Rev. F 8.23.2 Change Active Scan Mode 8.23.2.1 Duration of Scanning Mode Selections MM23772, Rev. F 8.23.3 Scan Priority 8.24 MAKE SELECTIVE CALLS MM23772, Rev. F 8.24.1 Manually Dialing a Selective Call (P7270 Only) 8.24.2 Selective Call Using Speed Dial MM23772, Rev. F 8.24.3 Accept a Selective Call 8.25 SELECTIVE ALERTS 8.25.1 Define Messages MM23772, Rev. F 8.25.2 Send a Message 8.25.2.1 Select a Destination Using the Keypad (P7270 Only) Page MM23772, Rev. F 8.26.2 Receive an Interconnect Call 8.27 EMERGENCY COMMUNICATIONS 8.27.1 Declare an Emergency Call or Alert MM23772, Rev. F 8.27.2 Receive an Emergency Call 8.27.3 Dismiss an Emergency 8.27.4 Clear an Emergency MM23772, Rev. F 8.28 OPENSKY ENCRYPTION (P7200 ONLY) 8.28.1 Automatic Encryption 8.28.1.1 Using Automatic Encryption 8.28.2 Manual Encryption (P7270 Only) MM23772, Rev. F 8.29 DYNAMIC REGROUPING 8.30 GPS COORDINATES 8.31 V-TAC FUNCTIONS 8.31.1 Extended Coverage Modes (XCOV and XCOV-TG) MM23772, Rev. F 8.31.2 Change Between Extended Coverage Modes 8.31.3 Use the XCOV Mode 8.31.3.1 Manually Access the XCOV Mode MM23772, Rev. F 8.31.4 Use the XCOV-TG Mode 8.31.4.1 Radio Limitations Using XCOV-TG 8.31.4.2 Access the XCOV-TG Mode Page Page 9 EDACS AND P25 TRUNKED OPERATION 9.1 TURN ON THE RADIO 9.2 CONTROLS MM23772, Rev. F 9.2.1 Buttons and Knobs Page Page 9.3 DISPLAY 9.4 RADIO STATUS ICONS 9.5 TRI-COLOR LED 9.6 STATUS MESSAGES MM23772, Rev. F 9.7 ERROR MESSAGES DSP ERR ERR=XXXX ERR x 9.8 ALERT TONES Page Page Page Page MM23772, Rev. F 9.18.1 Menu Item Selection Process or to scroll nor is an additional press of the button required. 70 Table 9-6: Information Display MM23772, Rev. F 9.19 DIGITAL VOICE OPERATION 9.19.1 Clear Mode 9.19.2 Digital Mode 9.19.3 Private Mode (P7200 Only) Page MM23772, Rev. F 9.19.4.2 Transmit an Encrypted Call 9.19.4.3 Scanned Group Calls 9.20 SCAN TRUNKED GROUPS 9.20.1 Turn Scan On and Off Page Page 9.21 SCAN TRUNKED SYSTEMS MM23772, Rev. F 9.21.3 ProScan 9.22 EMERGENCY OPERATION 9.22.1 Receive an Emergency Call 9.22.2 Declare an Emergency Call 9.22.3 Clear an Emergency Call Page Page Page MM23772, Rev. F 9.24.2.2 Direct Dial Phone Calls (P7270 Model Only) 9.24.3 Dual-Tone Multi-Frequency: Overdial/Conventional Mode Page MM23772, Rev. F 9.26.2 Message Operation 9.27 DYNAMIC REGROUP OPERATION ENTRY 9.27.1 Emergency Operation 9.28 MACRO KEY OPERATION MM23772, Rev. F 9.29 PORTABLE DATA 9.29.1 Displays 9.29.2 DATA OFF Operation 9.29.3 DATA ON Operation 9.29.4 Exit Data Calls Page 10 PROJECT 25 (P25) CONVENTIONAL OPERATION 10.1 TURN ON THE RADIO 10.2 CONTROLS MM23772, Rev. F 10.2.1 Buttons and Knobs Page Page 10.3 DISPLAY MM23772, Rev. F 10.3.1 Radio Status Icons 10.4 TRI-COLOR LED 10.5 STATUS MESSAGES MM23772, Rev. F 10.5.1 Error Messages DSP ERR ERR=XXXX 10.6 ALERT TONES 10.7 SYSTEM SELECTION Page Page Page Page 98 The TX POWER menu item, when selected, toggles LOW/HIGH power. It does not use or to scroll nor is an additional press of the button required. Table 10-5: Menu Item Information MM23772, Rev. F 10.17 DIGITAL VOICE OPERATION 10.17.1 Clear Mode 10.17.2 Digital Mode MM23772, Rev. F 10.17.3 Private Mode (P7200 Only) 10.17.3.1 Display the Currently Used Cryptographic Key Number 10.17.3.2 Key Zero MM23772, Rev. F 10.17.4 Private Operation (P7200 Only) 10.17.4.1 Receive an Encrypted Call 10.17.4.2 Transmit an Encrypted Call 10.17.4.3 Scanned Group Calls MM23772, Rev. F 10.18 GROUP CALLS IN P25 MODE 10.18.1 Transmit a Group Call 10.18.2 Receive a Group Call 10.19 INDIVIDUAL CALLS IN P25 MODE 10.19.1 Transmit an Individual Call 10.20 EMERGENCY GROUP CALLS IN P25 MODE 10.20.1 Declare an Emergency Group Call 10.20.2 Receive an Emergency Group Call 11 CONVENTIONAL OPERATION 11.1 CONTROLS MM23772, Rev. F 11.1.1 Buttons and Knobs Page Page MM23772, Rev. F 11.2 DISPLAY 11.2.1 Radio Status Icons MM23772, Rev. F 11.3 TRI-COLOR LED ERR x 11.4 STATUS MESSAGES 11.4.1 Error Messages DSP ERR ERR=XXXX Page Page Page Page Page 115 Table 11-5: Menu Item Information 11.17 RECEIVE A CALL 11.18 TRANSMIT A CALL 12 TECHNICAL ASSISTANCE 12.1 IMMERSIBLE P7200 118 13 BASIC TROUBLESHOOTING BATTERY WARRANTY WARRANTY