Tyler Refrigeration NSSD Nssd, Tyler Refrigeration, Anti-SweatReplacement, Page, March

NSSD Tyler Refrigeration

Anti-Sweat Replacement

WARNING

Shut off or disconnect power supply to case before changing an anti-sweat. Electrical power from wire ends could damage other components and/or cause personal injury or death.

Top Light Channel Anti-Sweat Replacement

1.Remove screws (1) and lower the top light channel assembly (2) from top of the case (3).

2.Disconnect or cut the defective anti-sweat wires (4) from the case wires.

3.Remove and replace the aluminum tape

(5) and defective anti-sweat wire (4) from the back of the top light channel assem- bly (2).

4.Position new anti-sweat wire (4) in case ) and secure with new aluminum tape (5).

5.Reconnect the new anti-sweat wires (4) to case wires and reinstall the top light channel assembly (2) with screws (1).

6.Restore electrical power to the case.

Front Curved Plexiglas

Replacement

1.Remove two screw (1) and plexiglas joint trim (2) from both joints of the damaged plexiglas (3).

2.Remove damaged plexiglas (3) from plexi- glas retainer (4).

3.Position new plexiglas (3) in plexiglas retainer (4).

4.Install plexiglas joint trim (2) with screw

(1) over the joint areas of plexiglas (3).

Page 16 March, 2002