Wire Shelf Removal/Installation
For ADA models equipped with wire racks, reposition the shelves as follows:
Figure 1
1.Remove shelf retention clip.
2.Pull shelf out about 6" (1), until back of shelf clears the “hump” on the
3.Tilt up
4.Remove shelf from unit by pulling out (3).
Insert the shelves as follows:
1.To move to a different position in the unit, insert shelf at an angle, approximately
2.Continue to slide the shelf into the unit at an angle until it clears the door.
3.Lower the shelf and push it in completely.
Install shelf retention clip.
14 |