U-Line 2175BEVOL2 manual Reversing the Door

2175BEVS/2175BEVOL2 Beverage Center

Final finish-only application:

1.Remove all screws securing wood trim to interior components, and remove the trim.

2.Lightly scruff sand the wood trim with 280 or finer grit sandpaper.

3.Remove sanding dust with a clean, dry cloth.

4.The factory-applied seal is compatible with virtually all

finishes. A low odor, water clean up, quick-drying finish such as Minwax® Polycrylic® Protective Finish is recommended (Minwax® Polycrylic® is an ultra fast- drying water-based finish). Apply a thin coat of a clear, protective finish, following the container label directions.

5.Lightly sand and reapply if desired.

6.Allow the final coat to dry for 24 hours before reinstalling the trim to the cabinet interior components.

Hinge plugs

Figure 8

3.Remove top hinge (3 screws), reinstall hinge screw pin, and remount on opposite side BOTTOM (Figure 9).

Reversing the Door

(All U-Line units (except Stainless Steel models) may be left- or right-hand opening. The door opening is easily reversed by moving the hinge hardware to the opposite side. The top hinge hardware will be used on the bottom of the other side and the bottom hinge hardware will be used on the top of the other side (see Figure 7).

To reverse the door:

1.Using a Phllips screwdriver, remove top hinge screw pin from door (Figure 7). Remove door by tilting forward and lifting off bottom hinge pin.

ULIN_0015_A

Figure 7

2.Remove metal hinge plugs (3 each, top and bottom) from new hinge location. Do not discard (Figure 8).

hinge screw pin

hinge screws

ULIN_0003_A

Figure 9

4.Remove the two door closer inserts from the existing bottom hinge and install as shown on the new bottom hinge (Figure 10).

door closer inserts

Figure 10

5.Remove existing bottom hinge (3 screws) and remount on opposite side TOP. Remove hinge screw pin.

6.Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side.

www.U-LineService.com 8 03/2008