7 Door Reversal
BI95 & BI98
Reversing the Door
All units may be left- or
Note: The grille should not yet be installed. If it has been installed, remove it for door reversing.
To reverse the door:
1.Remove top hinge from cabinet (three screws). See Figure 1. Hold door to keep it from falling.
2.Lift the door off the bottom hinge.
1 | 2 |
3.Remove bottom hinge from cabinet (two screws). See Figure 2. Remove screws on opposite side of cabinet (Figure 3). Note that there may be a nut behind one or both screws on either side.
3 | 4 |
4.Install hinge on opposite side, bottom of cabinet. See Figure 4. Replace nut on
back side where installed. Align hinge outer edge with cabinet before tightening screws.
5. Relocate plastic spacer/ |
|
bushing on bottom of door |
|
to opposite side, and place |
|
door on bottom hinge pin. |
|
See Figure 5. Clean out | 5 |
bushing hole in door bottom |
|
with a screwdriver if necessary. |
|
6.Remove plastic hole plug from door handle and relocate on opposite side. See Figure 6.
| Hinge |
|
|
Plastic |
|
| Plastic |
Plug Hole |
|
| Plug Hole |
| Screw |
|
|
Right Side |
|
| Left Side |
Door Swing |
|
| Door Swing |
Right Side | Invert | Invert | 6 |
Hinge | Screw | Hinge |
7.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. See Figure 7.
8.Remove three plastic screw
plugs from hinge holes, top of cabinet, opposite side. Be careful not to scratch
cabinet. See Figure 8.
9. Place door on lower hinge pin. Invert and install upper
hinge on door.
10. Fasten upper hinge to unit (three screws). Partially
tighten screws. See Figure7 9.
11.Adjust door to assure proper seal. Tighten upper and lower
hinge screws securely.
12. Replace three plastic plugs removed in Step 8 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.
8
9 |
