SS1095
Reversing the Door
Depending upon the location of the unit, it may be desirable to change the side on which the door is mounted.
To reverse the door mounting, perform the following:
1. Remove grille (one screw) (Figure 19).
7.Relocate plastic spacer/bushing (Figure 24) on top and bottom of door to opposite side. Clean out bushing hole in door bottom with a screwdriver if necessary.
8.Using a Phillips screwdriver, remove the two screws holding the custom stainless handle from the original location, and remove the handle. Remove the two screws on the opposite side of the door (Figure 25). Do not place handle on door until you have completed, steps 9 & 10.
Mod el |
| Mod el |
SS1095FC | Grille | SS1095FD |
|
| |
| screw |
|
19
2.Remove top hinge from cabinet (three screws) (Figure 20). Hold door to keep it from falling.
25
Hinge
Hinge screws
Plastic
Plug Hole
| Screw |
Right Side |
|
Door Swing |
|
Right Side | Invert |
Hinge | Screw |
| Plastic | |
| Plug Hole | |
| Left Side | |
| Door Swing | |
Invert | 26 | |
Hinge | ||
|
3. Lift the door off the bottom hinge.
9. Remove plastic hole plug (Figure 26) from door handle and
20relocate on opposite side. Lift the handle slightly and press on the locking tab, then gently pry the hole plug out of the hole being careful not scratch the top cap.
4. Remove bottom hinge from cabinet (two screws) (Figure 21).
Press in locking tab, then lightly pry up to remove hole plug and move to opposite side
27
21 | 22 | 10. Relocate plastic spacer/bushing on top of door that was |
|
| underneath the hinge to the opposite hole in top cap |
5.Remove screws on opposite side of cabinet (Figure 22).
6.Install hinge on opposite side, bottom of cabinet (Figure 23). Align hinge outer edge with cabinet before tightening screws.
1
11.Attach handle removed in step 7 to opposite side of door frame. Be sure to tighten all four screws removed in step 7.
12.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge (Figure 27).
2324
11 |
