U-Line CLRCO2075 manual Remove 12 screws and back panel

CLRCO2075 — Clear Ice Maker/Refrigerator ™

Disposal Assembly
Air Gap
(Optional Hook-Up)
	Waste
	Cold
Hot	Water
Water
	Shut-Off
	Valve
Figure 33

Spigot Assembly
Air Gap
(Optional Hook-Up)
	Waste
	Shut-Off
	Valve
	Cold
Hot	Water
Water
Figure 34

IMPORTANT

Before installing your U-Line CLRCO2075 with Factory- Installed U-Line P60 Pump, it is extremely important to check and test all hose connections at the drain pump. There is a possibility that hose connections may have loosened during shipment.

WARNING

To prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to, the unit.

To check and test hose connections:

1.Make certain the unit is not plugged into an electrical outlet.

2.Carefully push the power cord grommet through the hole in the back panel (see Figure 35).

Screws		Back
		Panel
	Grommet
	Drain	Water
		Connection
Power	Fitting
Cord
Figure 35

3. Remove 12 screws and back panel.

WARNING

Back panel serves as a guard. DO NOT put your hands inside the ice maker cabinet or attempt to touch any components except the discharge tube during testing. Failure to follow this warning could result in serious personal injury or death.

4.Check that the clamps and hose connections are tight at the following areas (see Figure 36):

•Discharge tube (A)

•Drain tube (B)

•Vent tube (C)

B	B
C	C
	A
Back View	Side View
Figure 36

www.U-LineService.com 14 02/2005