U-Line CLRCO2075 Drain Connection, Prepare Plumbing, Gravity Drain, Factory-Installed Drain Pump

™ CLRCO2075 — Clear Ice Maker/Refrigerator

6 Prepare Plumbing

CAUTION

Plumbing installation must observe all state and local codes. All water and drain connections MUST BE made by a licensed/qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm.

Drain Connection

IMPORTANT

Drain can NOT be located directly below unit. Unit has a solid base that will not allow unit to drain below itself.

The CLRCO2075 can be installed using a Gravity Drain, a Factory-Installed Drain Pump (U-Line P60) or a Locally- Installed Drain Pump. Drain lines must have a 5/8-inch inside diameter. The floor drain must be large enough to accommodate drainage from all attached drains.

Follow these guidelines when installing drain lines to prevent water from flowing back into the ice maker storage bin and/or potentially flowing onto the floor, causing water damage:

Gravity Drain

A Gravity Drain may be used if:

•Drain line has at least a 1-inch drop per 48 inches of run (1/4 inch per foot).

•Drain line does not create traps or created traps are vented (see Figure 30).

Normal

Proper Drain

With Trap

Poor Drainage, Water Will Back Up

With Trap and Vent

Proper Drain

Figure 30

See Figure 31 for a typical Gravity Drain installation.

Gravity Drain
		Waste
		Shut-Off
		Valve
		Cold
	Hot	Water
	Water
Figure 31	Waste

If using a Gravity Drain:

1.Attach the 5/8-inch ID drain connection on the back of the unit to a 5/8-inch OD rigid tube, using a worm clamp.

2.Attach the other end of the rigid tube to your 5/8-inch ID drain line with a worm clamp.

3.Insulate the drain line, if necessary to prevent condensation. Go on to Water Supply Connection.

Factory-Installed Drain Pump

If your drain line will run up to a stand pipe, disposal assembly or spigot assembly or does not otherwise meet the requirements for a Gravity Drain, you may have ordered the CLRCO2075 with a U-Line P60 Drain Pump. See Figures 32, 33 and 34 for typical installations requiring a Drain Pump. If you need to install a P60 Drain Pump into your unit, see Locally-Installed Drain Pump on Page 15.

Stand Pipe
	Waste
	Shut-Off
	Valve
	Cold
Hot	Water
Water
Waste
Figure 32

02/2005 13 www.U-LineService.com