![](/images/new-backgrounds/1080228/8022833x1.webp)
™ | CLRCO2075 — Clear Ice Maker/Refrigerator |
|
8 Level the Unit
2.If the ice maker is not level, adjust the feet on the corners of the unit as necessary (see Figure 43).
Leveling Information
IMPORTANT
It is extremely important that the unit is level. If it is not level, the ice mold will not fill evenly.
A unit that is not level can cause a reduction in ice rate, uneven sized cubes or water spilling into the storage area, which will cause the ice in the bin to melt prematurely (see Figure 41).
Remember that floors near drains have a tendency to slope towards the drain.
Figure 41 |
Turn Foot to Adjust |
Figure 43 |
3.Check the levelness after each adjustment and repeat the previous steps until the unit is level. Go on to
9 Install the Unit.
1.Use a level to check the levelness of the ice maker from front to back and from side to side. Level should be placed along top edge and side edge as shown (see Figure 42).
Check |
Level |
Figure 42 |
Installation Tip
If the room floor is higher than the floor in the
02/2005 | 17 |