ULINE_0217_A |
Figure 19
5.Install hinge on opposite side, bottom of cabinet (Figure 19). Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws.
1
ULIN_0109_A
Figure 20
6.Relocate plastic spacer/bushing (Figure 20, 1) on bottom of door to opposite side, and place door on bottom hinge pin. Clean out bushing hole in door bottom with a screwdriver if needed.
| Hinge |
|
Plastic |
| Plastic |
Plug Hole |
| Plug Hole |
| Screw |
|
Right Side |
| Left Side |
Door Swing |
| Door Swing |
Right Side | Invert | Invert |
Hinge | Screw | Hinge |
|
| ULIN_0142_A |
Figure 21
7.Remove plastic hole plug from door handle and relocate on opposite side (Figure 21).
8.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge (Figure 21).
ULIN_0144_A |
Figure 22
9.Remove three plastic screw plugs in hinge holes, top of cabinet, opposite side; being careful not to scratch cabinet (Figure 22).
10.Place door on lower hinge pin. Invert and install upper hinge on door.
ULIN_0145_A |
Figure 23
11.Fasten upper hinge to unit (three screws) (Figure 23). Partially tighten screws until door is aligned.
12.Adjust door to assure proper seal. Tighten upper hinge screws securely.
13.Replace three plastic plugs removed in Step 10 into holes on top of unit. Replace screws in holes in bottom of unit, opposite side.
14.
2
1
ULIN_0214_A
Figure 24
CO29FF | 13 |
