User’s Manual

12.Adjust door to assure proper seal. Tighten upper hinge screws securely.

13.Replace three plastic plugs removed in step 8 into holes on top of unit. Replace screws in holes in bottom of unit, opposite side.

14.Reinspect door seal and alignment. Adjust if needed.

15.Reinstall grille (1 screw).

NOTE

On Combo Model 75A (built-in installations only), changing the door mounting to the left side may interfere with ice bucket removal. See BUILT-IN INSTALLATION section for clearance requirements.

To reverse the door mounting on Models Combo 75A and 75R (except Stainless Steel models) perform the following:

1.Remove grille (1 screw). See Figure 15.

2.Remove top hinge from cabinet (4 screws). See Figure 16. Hold door to keep it from falling.

3.Lift the door off the bottom hinge.

4.Remove four plastic plugs in hinge holes, top of cabinet, opposite side (see Figure 22). Be careful not to scratch cabinet.

5.Remove pivot screw from top

hinge, invert screw and reinstall pivot screw in top hinge. See Figure 21. Do not install hinge on cabinet at this time.

6.Remove bottom hinge from cabinet (4 screws) and

screws on opposite side of cabinet (see Figure 24).

7.Remove pivot screw from bottom hinge, invert screw and reinstall pivot screw in hinge (see Figure 21).

UL128

Figure 24

16