User’s Manual
Install the insert as follows:
!
Insert edges may be SHARP! Use care when installing.
1.Remove top hinge screw pin (large Phillips head, see Figure 28). Hold door to keep it from falling.
2.Remove door, being careful not to scratch top of door on hinge.
3.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see Figure 29). This may take some force.
UL131
Figure 28
4.Remove two small screws holding door handle. Slightly separate door handle from door (see Figure 30).
5.Pull handle up and off.
UL117
Figure 29
UL132
Figure 30
20