NOTE

Use care not to bend light switch bracket (where installed), located on door bottom when installing door insert. Do not set door on bottom edge when pushing insert into place.

6.Slide custom door panel insert into 1/4 inch channel in door front.

7.Holding door gasket out of the way, replace handle on door mak- ing sure it is seated properly on insert and that screw holes line up.

8.Install two small screws removed in step 4.

9Starting at the center and working outward, push door gasket into place on door.

10.Place door on bottom hinge pin and install upper hinge screw (see Figure 28).

11.Reinspect door seal and alignment. Adjust if needed.

BUILT-IN INSTALLATION

Your U-Line product has been designed for either free-standing or builtin installation. When built-in, your U-Line product does not require additional air space for top, sides, or rear. However, the front grille must NOT be obstructed.

NOTE

Combo Models 29A, 29FF, and 75A require additional clearance when the door opens from the right (see Figures 32 and 33). This additional clearance allows for the ice bucket to be removed from the unit.

Unit Dimensions

Model

Width

Height

Depth

SP18

13-15/16"

18-1/2"

25-1/4"

95

13-13/16"

24-3/4"

17"

98

14-13/16"

27-3/8"

20"

15 Series

14-15/16"

34 - 35"

23-3/4"

29 Series

20-13/16"

28-1/2"

24"

75 Series

23-7/8"

34 - 35"

24"

21