U-Line BI95, SP18, BI98 manual Ice Maker Maintenance

6.Insert the grille screw (Figure 8, 1) and tighten. Do not over-tighten.

7.Reconnect power to the unit.

Ice Maker Maintenance

Inlet Screen

Interval - Every Twelve Months

The solenoid valve inlet screen must be cleaned at least once each year as follows:

WARNING

Disconnect electrical power to the unit before cleaning the solenoid valve.

Models 95 and 98

1.Disconnect electrical power to the unit.

2.Shut off the water at the main supply valve.

1

ULIN_0238_A

Figure 9

3.With a standard blade screwdriver or 1/4" nut driver, remove the grille screw (Figure 9, 1).

4.Remove the grille.

WARNING

DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged.

2

1

ULIN_0064_A

Figure 10

5.Disconnect the hose connector (Figure 10, 1) from the water solenoid valve (Figure 10, 2).

6.DO NOT remove the inlet screen from the water solenoid valve. Use a toothbrush to gently clean any sediment from the inlet screen.

7.Re-connect the water supply hose connector (Figure 10, 1) to the water solenoid valve (Figure 10, 2). Tighten the connector securely.

8.Open the water main supply valve and check for leaks at the water hose connection. Ensure that the water supply line is not kinked.

9.Place the two hook-hinges (located on the rear bottom side of the grille) on the front lip of the unit base. Swing the grille up into position, aligning the grille and cabinet screw hole.

10.Insert the grille screw (Figure 9, 1) and tighten. Do not over-tighten.

11.Reconnect power to the unit.

Model SP18

1.Disconnect electrical power to the unit.

2.Shut off the water at the main supply valve.

3.Pull the unit out to access the back panel.

2

1

ULIN_0065_A

Figure 11

4.Disconnect the hose connector (Figure 11, 1) from the water solenoid valve (Figure 11, 2).

5.DO NOT remove the inlet screen from the water solenoid valve. Use a toothbrush to gently clean any sediment from the inlet screen.

6.Re-connect the water supply hose connector (Figure 11, 1) to the water solenoid valve (Figure 11, 2). Tighten the connector securely.

7.Open the water main supply valve and check for leaks at the water hose connection. Ensure that the water supply line is not kinked.

8.Reconnect power to the unit before re-installing.

BI95, BI98, SP18 11