Ice Cube Thickness Adjustment
Interval - As Required
The ice cube size may be adjusted by changing the amount of water injected into the ice maker assembly as follows:
ULIN_0237_A |
Figure 12
1. Remove the ice maker assembly cover (Figure 12).
ULIN_0056_A |
Figure 13
2.Locate the adjusting screw on the ice maker assembly control box. The adjusting screw is just below the minus
NOTE: Make adjustments in small increments. Too large of an adjustment could cause the unit to malfunction.
3.Turn the adjusting screw toward the minus
4.Install the ice maker assembly cover.
IMPORTANT
Use only genuine
Leveling
IMPORTANT
It is extremely important that the unit sits on a level surface, as it does not have feet levelers. If it is not level, the ice mold will not fill evenly.
Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (Figure 15, 1).
1 |
ULIN_0309_A |
Figure 14
12 | BI95, BI98, SP18 |