U-Line BI95, SP18, BI98 manual Invert

5.Remove screws on opposite side of cabinet (Figure 19). Note that there may be a nut behind one or both screws on either side.

ULIN_0123_A

Figure 20

6.Install hinge on opposite side, bottom of cabinet (Figure 20). Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws.

1

ULIN_0109_A

Figure 21

7.Relocate plastic spacer/bushing (Figure 21) on bottom of door to opposite side, and place door on bottom hinge pin. Clean out bushing hole in door bottom with a screwdriver if necessary.

	Hinge
Plastic		Plastic
Plug Hole		Plug Hole
	Screw
Right Side		Left Side
Door Swing		Door Swing
Right Side	Invert	Invert
Hinge	Screw	Hinge
		ULIN_0142_A

Figure 22

8.Remove plastic hole plug (Figure 22) from door handle and relocate on opposite side.

9.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge.

ULIN_0144_A

Figure 23

10.Remove three plastic screw plugs (Figure 23) from hinge holes, top of cabinet, opposite side. Be careful not to scratch cabinet.

11.Place door on lower hinge pin. Invert and install upper hinge on door.

ULIN_0145_A

Figure 24

12.Fasten upper hinge to unit (three screws) (Figure 24). Partially tighten screws.

13.Adjust door to assure proper seal. Tighten upper and lower hinge screws securely.

14.Replace three plastic plugs removed in Step 10 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.

15.Replace the grille.

14 BI95, BI98, SP18