3 Product Operation
Air Flow
IMPORTANT
The unit requires proper air flow to perform at its highest efficiency. Do not block the front grille or internal fans at any time, or the unit will not perform as expected. Do not install the unit behind a door.
Initial Startup
All
IMPORTANT
To turn the unit on or off, press and hold POWER (1) for about ten seconds and release. The display will show the unit
Electronic Control Panel
Digital Display.
The electronic control with digital display shows a single continuous
Turning the Display Off. Wine Captain® Models and Glass Door Refrigerators have a DISPLAY OFF mode available through the control panel. This allows you to control if the display will be ON or OFF with the door closed. The icon sequence that follows will switch between both modes, On or Off:
1.Press and hold WARMER (2), and simultaneously within five seconds press POWER (1) three times.
2.The display will be either visible or dark with the door closed. To return to the previous mode, repeat Step 1.
Adjusting Air Temperature
IMPORTANT
Adjust the set point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking.
1 | 2 | 3 | 4 | 5 |
To adjust the set point temperature:
1.Press and release either WARMER (2) or COOLER (4) to put the controller in the SET TEMPERATURE mode. The display
(3)will begin to flash the °F (or °C) symbol.
NOTE: This mode will
2.Within five seconds (while the °F (or °C) symbol is flashing), press WARMER or COOLER as required to adjust the set point temperature.
3.The change is committed five seconds after adjusting the temperature, and the display (3) will show the new
Temperature °F °C Selection.
Easily adjust the display for either type temperature display.
Press and hold LIGHT (1) and simultaneously within five seconds press COOLER (5) three times to change the display
(3) as needed.
Temperature Display. The digital display shows
To display actual temperature:
1.Press WARMER (2) for five seconds. The display (3) will indicate the actual temperature.
2.After about 10 seconds, the set point temperature will return to the display.
3 |