U-Line Wine Captain 17

5.Remove existing bottom hinge (3 screws) and remount on oppo- site side TOP. Remove top hinge screw pin.

6.With bottom of door facing up, remove pivot plate and bushings (2 screws), flip over, and remount on opposite side of door (see Figure 10).

UL319a

Figure 10

7.Holding door upright with top of door tilted forward, place hole of door pivot plate on bottom hinge screw pin (see Figure 11). Be sure that the bosses on the closers align with holes in hinge and hinge plate.

8.Tilt top of door into position in top hinge and install top hinge screw pin.

9.Install plastic screw plugs removed in Step 2 in existing hinge holes (3 each, top and bottom).

BOSS

CLRCO008

Figure 11

15

Contents

Page Page PLEASE RECORD YOUR MODEL’S INFORMATION WARRANTY REGISTRATION CARD NOTE Page Page A DRY WINE Before A SWEET WINE A WHITE WINE Before A RED WINE A YOUNG WINE Before An OLD WINE A LIGHT-BODIEDWINE Before A FULL-BODIEDWINE Fish, Shell Fish, Crab, Oysters Red Wines White Wines Acidity: Balance: Body: Bouquet: Complex: DEFINITIONS GENERAL PRECAUTIONS SITE PREPARATION NOTE WOOD TRIM ON WINE RACKS To stain for a different wood color: Page Page Page TO ADJUST DOOR: Page Unit Dimensions THE RIGHT TEMPERATURE FOR WINE PROPER STORAGE CONTROL SETTINGS LIGHT SWITCH AND BULB CHECKING TEMPERATURE DISPLAY RACK STOCKING RECOMMENDATIONS EXTERIOR CLEANING — AS REQUIRED INTERIOR CLEANING — AS REQUIRED CONDENSER CLEANING - EVERY 3 MONTHS WINE RACK REMOVAL/INSTALLATION BULB REPLACEMENT BEFORE CALLING FOR SERVICE IF SERVICE IS REQUIRED REPLACEMENT PARTS Troubleshooting — What to check when problems occur Page Page P . O . B o x 2 4 5 0 4 Milwaukee, WI P h o n e : 4 1 4 . 3 5 4 . 0 3 0 F a x : 4 1 4 . 3 5 4 . 7 9 0 w w w . u - l i n e . c o m