User’s Manual

DOOR ADJUSTMENT

Your Wine Captain doors were aligned at the factory before shipment. Occasional re-adjustment may be necessary. The following procedure will correct for up to 1/4" alignment.

The door should never be flush with the top of the cabinet. Even when level, the top edge of the door will be 1/8" below the top of the cabinet (see Figure 12).

TO ADJUST DOOR:

1.Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the type (up or down) of adjustment needed.

1/8"

DOOR001a

Figure 12

2.Remove the top hinge pivot pin with a 7/64" hex wrench (see Figure 13) and lift door off bottom hinge pin. Be careful not to lose door closer inserts (see Figure 15).

3.With door upside-down, inspect the bottom hinge plate mounting holes.

a. If your plate has slotted mounting holes, loosen but do not remove the two hinge plate screws.

b.If your plate does not

have

slotted

mounting

 

holes,

remove

the old

 

plate and install the new

 

plate with the notch to

 

the inside of

the door

UL310

(see Figure 14).

Figure 13

 

 

 

16