Preparing the handsets
Installing and charging the handset battery pack
1On each handset:
Remove the battery compartment cover. Press down on the
Connect the supplied battery pack with the correct polarity.
Slide the battery cover back until it clicks securely into place.
2To charge the battery, place the handset(s) on the base or on a charger. The charging light in the base illuminates. While charging, the
symbol 
scrolls and when the handset is fully charged, all the bars of the battery symbol will be filled when the phone is off the cradle.
If the charging light does not come on, reposition the handset in the base or charger, ensuring that the charging points contact. You must charge each handset for
NOTE: Once your handset is fully charged, your phone is designed for the base charge LED to turn off for approximately 4 seconds during the following instances:
1)just after reaching a full charge
2)1 minute after reaching a full charge
3)every 5 minutes after reaching a full charge
To alleviate the charge LED from blinking on the base, you can simply remove the handset from the charging cradle.
You may also select to leave the handset in the cradle, which will not damage the unit. Once fully charged, you may notice the charge LED light will turn for 4 seconds every 5 minutes. This is normal operation and does not mean your unit is defective.
WARNING
Under no circumstances should non- rechargeable batteries be used. Only use the supplied battery pack or you will invalidate your guarantee and may damage the telephone.
[5]
