Finding a Lost Handset
To locate a misplaced handset, press [find] on the base when the phone is in standby. The handsets connected to the paging base will beep for one minute, and PAGING appears on the handset display. To cancel paging, press [find] again or any key on the found handset.
Note: Handsets that are not currently connected to this base will not be paged.
Using Hold, Conference and Transfer
Placing a Call on Hold
) During a call, press [Int’com/clear] to place the caller on hold. If you leave a caller on hold for more than ten seconds, the display screen will read, LINE ON HOLD.
2) To return to the party on hold, press [
/flash] or [
]. The phone will return to the holding party.
Notes: • You can only place a caller on hold for five minutes. Once five minutes has passed, that party’s line will be disconnected and the phone will return to standby.
• While a call is on hold, Call Waiting and CID on Call Waiting do not work.
Conferencing | Outside call |
If you have more than one handset, up to three people can |
|
participate in a conference call. A |
|
consists of an outside line and two handsets. You can easily |
|
join a call already in progress. The handsets must be currently |
|
connected to the same base (see page 14). | Handset #2 |
) Press [
/flash] or [
] to join the call.
2) To hang up, return the handset to the cradle or press [
]. The other party will still be connected to the call.
Handset #1
Finding a Lost Handset
Using Hold, Conference and Transfer
38
