[48]
Toreset the handset, do the following:
[ ] [#/>]
Note: It is also possible to reset the handset back to itsoriginal factory settings. All changes including
phonebook entries and Caller ID information will be erased. For more information on resetting the
handset back to factory settings and when you need to do this, visit the customer support pageat
www.uniden.au(Australian Model) or www.uniden.co.nz (New Zealand Model).
[ ] [#/>]
1. Press and hold and for at least 5 seconds until the SYSTEM RESET menu appears.
Select DEREGISTER HS submenu. WHICH HANDSET? appears.
2. Move the cursor to select the handset ID to be deregistered from the list, and then press .
DEREGISTER HS appears.
3. The phone will ask you to confirm the deregistration. Move the cursor to YES, and then press .You
will hear a confirmation tone.
When the base information is deleted, the handset displays MODELS VARY!CHARGE HANDSET ON THE
BASE FOR REGISTRATIONOR REFER TO OWNER'S MANUAL. To register the handset to the new base, see
page24.
If the handset cannot contactthe base, it displays UNAVAILABLE. Make sure the handset is in range of the base
and the base is connected to power.
If your original base is not available for some reason (for example, it is
lost or somehow incapacitated),you can still reset the handset and use
it with another base.
1. Press and hold and for at least 5 seconds until the
SYSTEM RESETmenu appears.
2. Move the cursor to select the REPLACING BASE submenu, and then
press . REPLACE BASE appears.
3. Move the cursor to select YES, and then press . A confirmation tone sounds.
The handset deletes itsown base information without trying to contact the base. When the base information is
deleted, the handset displays MODELS VARY!CHARGE HANDSET ON THE BASE REGISTRATION OR
REFERTO OWNER'S MANUAL. To register the handset to the new base, see page 24.
[select/ ]
[select/ ]
[select/ ]
[select/ ]
Resetting the Handset without the Base