Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base. Your unit ships from the manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you suspect another cordless telephone is using the same security code or if you are instructed to change this code by a manufacturer’s Call Center Representative, you can change the code by:

.Perform “Resetting the Handset” for all of your handsets by following the steps on page 26.

2.Re-register each handset by placing in the base charging cradle.

Traveling Out of Range

During a call, if you move your handset too far away from your base, noise may increase. If you pass the range limits of the base, you will hear a beep and see OUT OF RANGE on the display, and then the handset returns to standby.

Common Issues

If your phone is not performing to your expectations, please try these simple steps first. If these steps do not solve your problem, please call our Customer Hotline. See back cover page for contact information.

Symptom

 

Suggestion

The charge/in use LED won’t

Make sure the AC adaptor is plugged into the base or the charger (if you have

illuminate when the handset

 

more than one handset) and wall outlet.

is placed in the cradle.

Make sure the handset is properly seated in the cradle.

 

Make sure the charging contacts on the handset are clean.

The audio sounds weak.

Move the handset and/or base away from metal objects or appliances and try

 

 

again.

 

Make sure that you are not too far from the base.

69

Page 70
Image 70
Uniden DSS7955+1, DSS7955+2 Changing the Digital Security Code, Traveling Out of Range, Common Issues, Symptom Suggestion