Manuals / Uniden / Communications / Cordless Telephone

Uniden EXP2905 manual Preparing the battery pack

Models: EXP2905

1 40

Download 40 pages 14.51 Kb

Page 11

Image 11

Step 3

Preparing the battery pack

Charge the battery pack for 15-20 hours before you start using your phone.

1 Slide open the battery compartment lid of the handset.

2 Connect the battery connector with correct polarity (black wire goes on

Getting Started

BT-905

left side and red wire goes on right).

Red

Black

3 Close the battery compartment lid.

4 Place the handset on the base phone.

The CHARGE LED lights up when the handset is properly seated on the charge terminals of the base phone. Charge the battery pack for 15-20 hours so that the battery is fully charged. The CHARGE LED remains lit even after charging is completed.

CHARGE LED

continued

Getting Started

Page 11

Image 11

Uniden EXP2905 manual Preparing the battery pack

Contents

Page Important Safety Instructions PrecautionsImportant Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Outlets Installation ConsiderationsTable of contents About the digital security code Read this firstStep Choose the best location Setting up the base phoneIf you want to hang the base phone on the wall, see Connect the base phoneTip Choose the dialing modeIf your dialing system is Set the switch to If you aren’t sure of your dialing systemPreparing the battery pack When to purchase a new battery pack Battery durationTo obtain the best performance from the battery Talk button p Dialing keys p Battery compartment pSET UP button p Antenna SpeakerMIC microphone Base Phone Edit button pDialing keys p Charge LED pDC in 9V jack p Line telephone line jack Do this Additional tasksMaking calls through the speakerphone If the handset battery becomes weak during a callOn the base phone RedialingMaking calls On the handsetReceiving calls through the speakerphone Receiving callsStoring phone numbers on the handset Memory dialingStoring phone numbers on the base phone Telephone FeaturesTo change a stored number Making calls with memory dialing on the handsetMaking calls with memory dialing on the base phone Memory dialing To store the previous number dialedTo turn the ringer on again Setting the ringer typeTurning off the ringer Checking the ringer type Adjusting the ringer volume level of the base phoneSetting the ringer type To switch from the base phone to the handset Switching the phones during a callSwitching the phones during a call To switch from the handset to the base phoneTips When you are done talking or if no one answers the phoneTalking between the handset and the base phone Intercom To talk from the handset to the base phoneTalking between the handset and the base phone Intercom When you are done talking or if noTo talk from the base phone To the handsetIf no one answers the phone Transferring a callTo transfer from the base phone to the handset Transferring a call To transfer from the handset to the base phoneTo join the phone conversation When you are done talkingHaving a three-way conference Additional Information Mounting the base phone on a wallCalls TroubleshootingSymptom Remedy Power source/battery Intercom Memory dialing Symptom Remedy MaintenanceBase phone SpecificationsGeneral HandsetIndex Page Page Uniden America Corporation