Installation
Selecting a Location
Before choosing a location for your new phone, read the “Installation Considerations” included in the “Precautions and Important Safety Instructions” brochure.
Important: Place the power cord so that it does not create a trip hazard, or where it could become chafed and create a fire or other electrical hazards.
Setting the Dial Mode Switch
Place the switch in the
T position for tone dialing, or the P position for pulse dialing.
Desk or Tabletop Installation
1. Plug the AC adapter cord into the 9V DC input jack on the base.
2. Wrap the AC adapter cord inside the molded
3.Plug one end of the long telephone cord into the
TEL LINE jack on the base.
4. Raise the antenna on the base.
5. Plug the other end of the telephone cord into the telephone wall jack.
6.Plug the AC Adapter into a standard 120V AC wall outlet that is not controlled by a wall switch.
Use only the AC adapter that came with the phone.
Wall Installation
▼Setting the Handset Retainer For Wall Mounting
1.Remove the handset retainer on the base by
sliding it upward.
2.Flip the retainer over so the tab is facing up.
3.Slide the retainer back into the base.
▼Mounting on a Standard Wall Plate
The phone is designed to be mounted on a standard AT&T or GTE wall plate.
1. Plug the AC Adapter into the base.
2. Place the AC Adapter cord inside the left channel cord holder.
3. Plug a short telephone cord into the phone and the wall plate jack.
4. Place the base on the two posts of the wall plate and slide downward to secure.
5
