Connect the base unit, AC adapter | Uniden EXT3165 specification

•Use only the supplied AD-446 AC adapter. Do not use any other

AC adapter.

•Place the power cord so that it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.

C. Connect the base unit

Route the cord.

1) Connect the AC adapter to the DC IN 9V jack and to a standard 120V AC wall outlet.

2) Set the base on a desk or tabletop, and place the handset in the base unit.

3)Make sure that the charge/in use/voicemail LED illuminates.

If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts.

•Connect the AC adapter to a continuous power supply.

•Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.

•After installing the battery pack in the handset, charge your handset at least 15-20 hours before plugging into the phone line.

4) Connect the telephone line cord to the TEL LINE jack and to a telephone outlet once the handset is fully charged.

If your telephone outlet isn't modular, contact your telephone company

for assistance.

Modular

[ 12 ] G E T T I N G S TA R T E D

www.uniden.com

Image 12

Uniden EXT3165 manual Connect the base unit, AC adapter

Contents

Page Page Quick Reference Guide Contents Welcome Features Controls and Functions N T R O L S a N D F U N C T I O N S Setting up the Phone Choose the best locationDo the following steps Install the rechargeable battery pack into the handset E T T I N G S TA R T E D Battery use time per charge Low battery alertCleaning the charging contacts Connect the base unit AC adapter Mounting the Base Unit on a Wall Standard wall plate mounting Direct wall mounting Setting Menu Options Caller ID options Choosing the dialing mode Setting the language Making and Receiving Calls Handset On Base Handset Off Base Adjusting the Handset Ringer and Earpiece Volume Handset ringer tone and volumeEarpiece volume Temporarily Mute Ringer Tone Dialing Switch-over RedialTraveling Out-of-Range Selecting a Different Channel Flash and Call Waiting Storing Phone Numbers and Names Memory Dialing Steps for Entering Names and Special Characters If you make a mistake while entering a name Memory dialing from Standby Mode Making Calls with Memory Dialing Memory dialing from Talk Mode Chain Dialing Editing a Stored Name and/or Phone Number Replace Memory? Yes Memory01 Stored Movies Erasing a Stored Name and Phone Number Press select or delete/ch Using One Touch Voicemail Access Programming your Voicemail Access Number Deleting your Voicemail Access Number Dialing your Voicemail ServiceMessage Waiting Indicator When the Telephone Rings You must subscribe to Caller ID service to use this featureCaller ID Viewing the Caller ID Message List Press cid/menu When the pointer is at ¨Yes¨ When the pointer is at ¨No¨Deleting Information from the Caller ID List Deleting a Caller ID message Or vol/ring Using the Caller ID List Long Distance calls and Area Code Setting/CancellationCalling a party from the Caller ID list Features Storing Caller ID messages in Memory dialing Installing the Beltclip Headset InstallationChanging the Digital Security Code To attach the beltclip Maintenance Battery replacement and handlingPower Failure When the handset or base unit becomes slightly dirty Troubleshooting Symptom Suggestion Charge/in use/voicemail Symptom Suggestion Liquid Damage Case Action Battery Information General InformationAC Adapter Information Precautions Installation Considerations Terminal Equipment Radio Equipment K, L Memo Memo Memo At Uniden, we´ll take care of you