until your transmission is finished and then checks the channels.
Normal mode with DSC Watch
If you activate DSC Watch while operating in Normal mode, the radio checks channel 70 every few seconds.
Scan
Monitoring Channel 25
70 
70 
70
Every few seconds, the radio
checks channel 70
with DSC Watch on
You can save channels into memory and then use scan mode to monitor those channels from lowest to highest. If the radio detects a signal on a channel, it stays on that channel as long as the signal is received; when the signal stops, the radio continues scanning.
When it detects a signal, the radio stays on the channel until you press the
Channel Up button or the signal stops.Resume scan
08 |
| 10 |
| 11 |
| 12 |
| 13 |
| 14 |
|
| 15 |
| 17 |
|
|
|
|
|
|
The radio scans about
5 channels in 0.5 seconds.
Using the radio in scan mode
xx To activate scan mode, press and hold CLR/SCAN.
xx You must have at least two channels in memory to start a scan. xx You cannot transmit while in scan mode.
xx To save a channel into memory, select the channel, then press and hold the GPS/ MEM button. The MEM icon displays whenever you tune to that channel.
xx To remove a channel from memory, set the radio to that channel, then press and hold the GPS/MEM button. The MEM icon no longer displays.
xx When the radio stays on a channel, press Channel Up to leave that channel and resume scanning.
xx To end the scan, press and hold the CLR/SCAN button again; the radio remains on the last scanned channel.
Scan mode with Weather Alert Watch
If you activate Weather Alert Watch while in scan mode, the radio checks the most
Memory Channel Scan
08 
10 
11 
12 
13
Every few seconds, the radio checks the
14 
15 
17 
20 
24 
25
WX Alert
Watch on 
wx 
Scan mode with Triple Watch or Dual Watch
If you activate Triple Watch while operating in scan mode, the radio checks channels 16 and 9 every few seconds, then goes on to scan the next channel; with Dual Watch
Uniden MHS135DSC Radio Owner’s Manual |
