Operation

Before operating the PRO340XL:

1.Be sure that the power source and antenna are properly connected.

2.Turn the unit on by sliding the power switch up to the ON position.

Receive

"

I

1. Use the UplDownchannel keys to select any of the 40 channels. Press

once to change one channel at a time. Press and hold to rapidly change channels.

2. Set the VOLUMEcontrol to a comfortable listening level.

3.Adjust the SQUELCHcontrol to eliminate background noise during the absence of a signal. Move SQUELCHto the right until the noise disappears (no signal should be present). Leave the control at this setting. The receiver will remain quiet until a signal is actually received.

Note: Do not advance the control too far, or some weaker signals will not be heard.

Transm it

1.Set the HIILOWSwitch.

.

.

In the 'HIli(4 watt) position, the unit transmits at maximum'outputpower and achieves maximum range.

In the "LOW'(1 watt) position, transmission output power (range) is

substantially reduced; but, the battery life will be increased.

For maximum battery life, select the "LOW' position. This switch does not affect the reception range.

2.If the channel is clear, press the Push-Ta-TalkButton on the side of the unit. Be sure to speak clearly into the microphone.

IMPORTANT: All channels, except channel 9, may be used for normal communication. Channel 9 is reserved for emergency communications involving the immediate safety of individuals or the protection of property.

~

9

Page 11
Image 11
Uniden manual Operation, Before operating the PRO340XL