WHAM_UA466ZL UA01466ZA_0 9/20/02 12:50 PM Page 15
Troubleshooting
If the WHAM does not perform to your expectations, try the suggestions listed below, If you cannot get satisfactory results, call Uniden Technical Support at (800)
SYMPTOM | CAUSE | REMEDY |
Won’t power On. | No or low voltage. | Check for proper voltage. |
|
| Recharge or replace the |
|
| batteries. |
When the PTT is | Bad mic element. | Send in for repair. |
pressed - TX icon |
|
|
comes on and |
|
|
another radio can |
|
|
hear a “click” but no |
|
|
audio is heard. |
|
|
While scanning, the | A source of noise | Eliminate the source of |
radio stops on a | is nearby. | the noise or delete the |
particular channel all |
| channel from the |
of the time. |
| Scan Memory. |
There is noise on | An external noise is | Either turn off the |
the receiver that the | being generated by | offending device or |
squelch will not | some device. | contact that Mfg. |
eliminate. |
| Regarding FCC part 15 |
|
| “unintentional radiator”. |
WHAM won’t control | POLARIS is | Turn the POLARIS On. |
the POLARIS. | turned Off. |
|
Care and Maintenance
Your WHAM is a precision piece of electronic equipment and you should treat it accordingly. Due to the rugged design, very little maintenance is required. However, a few precautions should be observed:
•You are responsible for continued FCC technical compliance of your radio.
•You are urged to arrange for periodic performance checks with your Uniden Marine dealer.
15
