CONDITION |
| SUGGESTION |
| |||
Scan doesn't stop. | Adjust the Squelch setting. It | |||||
| may be too high. |
|
| |||
| Check | the antenna | connection. | |||
| Make sure the antenna is in a | |||||
| vertical | position. |
|
| ||
| Reception may be poor. See | |||||
| above | for suggestions. |
| |||
| It is possible that none of the | |||||
| programmed | frequencies | are | |||
| active | at the time. |
|
| ||
Scan doesn't start. | Make sure there are some | |||||
| programmed | channels. |
| |||
| The scanner may be in Manual | |||||
| mode. Press @ to begin |
| ||||
| scanning. |
|
|
| ||
| The scanner may be stopped on | |||||
| a weather frequency. Press @ | |||||
| to begin scanning. |
|
| |||
| Adjust the Squelch setting. It | |||||
| may be too Iow. |
|
| |||
| All the channels may be locked | |||||
| out. Tum off Lockout for the | |||||
| channels you want to scan. | |||||
Keypad won'twork. | Check | the Keylock. | Make | sure | ||
I | Keylock is off before |
| ||||
programming | or locking out | |||||
| ||||||
channels.
If you still cannot get satisfactory results and want additional
information, or to retum the unit for service, please call or write the Uniden Customer Service Division. The address and
phone number are listed in the Warranty (at the end of this manual).
22
