Marantz SR7005 manual Registering preset codes, nnButtons used for operating the devices, Svenska

SVENSKA NEDERLANDS ESPAÑOL ITALIANO FRANÇAIS DEUTSCH ENGLISH

Registering preset codes

When preset codes are registered in the included remote control unit, it can then be used to operate any devices you have, such as DVD players or TVs made by different manufacturers.

NOTE

•No preset codes other than BD, DVD, TV, SAT and CD can be registered.

•In the factory settings, remote control codes for all Marantz products are registered.

nnButtons used for operating the devices

qSOURCE ON/OFF

For switching power of each device on or off.

wuio p, ENTER

For menu operation of each device.

eMENU, SETUP, TOP MENU

For displaying the menu of each device.

r1, 2, 3, 6, 7, 8, 9 t Number button (0 – 9, +10)

y PRESET +, PRESET – u TV POWER, TV INPUT

For operating a TV.

This button is enabled in any mode.

For details on operation with the remote control unit, see pages 29 – 45, 94.

Registering preset codes

The following two methods can be used for registering the reset code.

qEntering a 4-digit code w Scanning the code table

qEntering a 4-digit code

See the preset code list table for the code to be input.

1 Press and hold down the input source select buttons for the appliance to control, and press SET untilindicator blinks twice.

The back light flashes.

2 Press the 4-digit code for the appliance using the numeric buttons (code table at the end of this book).

• The 4-digit code is shown in the remote control display.

• When the settings are complete, “OK” is shown in the remote control display.

• If “NG” is displayed in the remote control display, repeat steps 1 and 2, and enter the same code again.

wScanning the code table

1 Switch the power on of the device for which you want to set the preset code.

2 Press and hold down the input source select buttons for the appliance to control, and press SET untilindicator blinks twice.

The back light flashes.

3 Aim the remote control at the appliance and slowly alternate between pressing INPUT d and SOURCE ON/OFF for the appliance.

The preset code is shown in the remote control display.

4 Stop when the appliance turns off.

5 Press ENTER once to lock in the code.

Check the registered preset code

1 Press and hold down the input source select buttons for appliance to control, and press SET untilindicator blinks twice and back light flashes.

The back light flashes.

2 Press SEARCH/INFO.

The display flashes twice, after which the set code is shown for 3 seconds in the remote control display.

Simple version

Basic version

Advanced version

Information

93