Marantz SR7005 Connecting a wireless receiver RX101, nnAM loop antenna assembly, Standing alone

SVENSKA NEDERLANDS ESPAÑOL ITALIANO FRANÇAIS DEUTSCH ENGLISH

Connecting an antenna

nnAM loop antenna assembly

Connecting a wireless receiver (RX101)

Simple

1 Put the stand section through the bottom of the loop antenna from the rear and bend it forward.

2 Insert the projecting part into the square hole in the stand.

Stand

Square

hole

Loop Projecting

antenna part

By connecting a wireless receiver RX101 (sold separately) to this unit, you can receive and playback audio signals from other devices using the Bluetooth Communication Function.

•Use a Bluetooth device that is A2DP compatible (vpage 111 “A2DP”).

•You can also use wireless receiver RX101 as an external IR receiver.

•For instructions on the wireless receiver settings, refer to the RX101’s operating instructions.

Wireless receiver RX101

version

Basic version

nnUsing the AM loop antenna

Suspending on a wall

Suspend directly on a wall without assembling.

	Nail, tack, etc.
Standing alone	Bluetooth device
	(A2DP Compatibility)

Use the procedure shown top to assemble.

Advanced version

NOTE

•Do not connect two FM antennas simultaneously.

•Even if an external AM antenna is used, do not disconnect the AM loop antenna.

•Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.

•If the signal has noise interference, connect the ground terminal (GND) to reduce noise.

•If you are unable to receive a good broadcast signal, we recommend installing an outdoor antenna. For details, inquire at the retail store where you purchased the unit.

Remote control unit

You can enjoy listening to music by connecting a wireless receiver via the M-XPort input connector. In this case, set the input source to “M-XPort”.

NOTE

To use wireless receiver RX101 as external IR receiver, set the remote sensor function of this unit to “Remote Lock:ON” (vpage 91 “Remote control settings”).

23

Information