SVENSKA NEDERLANDS
1 2 3 4 5
ESPAÑOL ITALIANO FRANÇAIS DEUTSCH ENGLISH
4 Set up speakers |
|
|
|
|
|
(Audyssey® Auto Setup) | 1 | 2 | 3 | 4 | 5 |
|
The acoustic characteristics of the connected speakers and listening room are measured and the optimum settings are made automatically. This is called “Audyssey Auto Setup”.
To perform measurement, place the setup microphone in multiple locations all around the listening area. For best results, we recommend you measure in six or more positions, as shown in the illustration (up to eight positions).
•• When performing Audyssey Auto Setup, MultEQ® XT/Dynamic EQ®/Dynamic Volume® functions become active (vpage 76, 77).
•• To set up the speakers manually, use “Speaker Setup” (vpage 80) on the menu.
NOTE
•Make the room as quiet as possible. Background noise can disrupt the room measurements. Close windows, silence cell phones, televisions, radios, air conditioners, fluorescent lights, home appliances, light dimmers, or other devices as measurements may be affected by these sounds.
•Cell phones should be placed away from all audio electronics during the measurement process as Radio Frequency Interference (RFI) may cause measurement disruptions (even if the cell phone is not in use).
•Do not unplug the setup microphone from the main unit until Audyssey Auto Setup is completed.
•Do not stand between the speakers and setup microphone or allow obstacles in the path while the
measurements are being made. This will cause inaccurate readings.
• Loud test sounds may be played during Audyssey Auto setup. This is part of normal operation. If there is background noise in room, these test signals will increase in volume.
• Operating VOLUME +, – during the measurements will cancel the measurements.
• Measurement cannot be performed when headphones are connected.
Simple version
Basic version
Advanced version
Information
7
