SVENSKA | NEDERLANDS | ESPAÑOL | ITALIANO | FRANÇAIS | DEUTSCH | ENGLISH |
Other settings
Remote control settings |
| Switches light illumination on/off | ||||
• When you connect a remote control receiver unit (purchased |
| You can switch the lighting around the main display on or off. | ||||
separately) to the REMOTE CONTROL IN terminal of this unit, use |
| • The factory setting is “ON”. | ||||
the following procedure to disable the remote sensor function of |
|
|
|
|
|
|
|
|
|
|
|
| |
this unit. |
|
|
|
|
|
|
|
|
|
|
|
|
•The remote sensor function of remote control signals is enabled by default.
ON/STANDBY
DISPLAY
Press and hold DISPLAY on the main unit for 3 seconds.
• Carry out the same procedure if you want to change the settings again.
STATUS ENTER
nnDisabling the sensor function of the remote control unit
When the main unit is in standby mode, press ON/ STANDBY while holding down STATUS and ENTER on the main unit.
“Remote Lock:ON” is shown on the display, and the infrared light receiving function is disabled.
nnEnabling the remote sensor function
When the main unit is in standby mode, press ON/ STANDBY while holding down STATUS and ENTER on the main unit.
The infrared light receiving function on the main unit is enabled.
NOTE
If a remote control receiver unit (purchased separately) is not connected, do not perform this setting. If you do, you will not be able to operate this unit using the remote control unit.
91
Simple version
Basic version
Advanced version
Information