Uniden UBC 2500XLT manual Care and Maintenance, yourunit, To replace the Battery Pack, General Use

Care and Maintenance

Replacing the Rechargeable Battery Pack

When it is time to install a new Battery Pack, use only the one made for this scanner. Any other type of battery may damage

yourunit.

To replace the Battery Pack:

1.Remove the BeltClipby liftingthe tab and carefully sliding it upward and out.

2.Remove the Battery Pack by pressing in and slidingit down and off.

3.Install the new Battery Pack by sliding the pack onto the bottom of the scanner until it clicks.

4.Replace the Belt Cljp.

Note: Be sure to recharge the Battery Pack before using the scanner.

Battery Maintenance

Most rechargeable batteries typically suffer from "memory

effect"which occurs graduallyover time, shortening the usable time of the Battery Pack when it is fully charged. After 2 to 3 months of use, when the Battery Pack holds a charge for a somewhat shorter period than when first used, follow these steps:

1.	Leave the scanner on until the Battery Pack is drained.
	(See the Low Battery Indicator description in the
	"Controls and Indicators"section for more information.)
2.	Recharge the Battery Pack for 14 to 16 hours to ensure
	a full charge.
3.	After the Battery Pack is fully recharged, you may need	I
	to reprogram the channels.

General Use

. Turn the scanner off before removing the Battery Pack.

.	Always write down the programmed frequencies in the
	event of memory loss. If memory is lost, simply
	reprogram each channel.
.	Always press each keypad button firmly until you hear
	the entry tone for that key entry.

29