UNIDEN Model UH013 UHF CB Radio
Operation
Searching
Searching checks every frequency within the Band. If an active channel is located the UH013 will stop on that channel until 2 seconds after the transmission ends, then continue.
Search Hold
1.To stop the search, press SRCH at any time. HLD is displayed.
2.To continue, press SRCH again.
Skip
If a particular frequency continues to interrupt searching, you can set your radio to skip the frequency by pressing the INST button during search hold (you may skip up to 10 frequencies). To cancel Skip, press INST again while search holding at the desired frequency. To cancel all Skipped frequencies, press and hold
INST for 2 seconds during search hold.
Changing the Search Band
While searching press and hold SRCH for 2 seconds. The UH013 will move to the next band.
Rotary
Channel
Selector
SLCT
STORE
TX 
WS
MON SCN GS BCL INS
SLT SRC HLD SQT M
| MHz |
|
| S/RF |
|
|
|
| |
SRCH | SCAN | MEM | INST | SQT |
TSQ OS/GS DUP SET/SKIP CTCSS
VOL
Scanning Stored Frequencies
You may store up to 40 frequencies from any band into memory and then only scan those frequencies for activity.
1.Select Wide Band Scanning (see page 13).
2.Press SCAN .
3.To stop the Scan, press SCAN at any time. HLD is displayed.
4.To continue, press SCAN again.
Programming Scan Frequencies
1. Select wide band scanning (see page 13).
2.Press SCAN
3.Press SRCH
and turn the Channel selector to choose a memory location (41 - 80). to approach the desired frequency.
4.Turn the Channel Selector to stop searching and fine tune to the exact frequency.
5.Press MEM to store the selected frequency.
NOTE Repeat procedure as necessary to programme the other memory locations.
Deleting stored frequencies
1.Select the desired memory location.
2.Press and hold SCAN for 2 seconds to delete the selected frequency.
14
