Uniden UIP 160P owner manual Resetting the UIP160P, Power Cycle, Hard Reset

LED	On	Off	Blinking
WAN	The UIP160P detects a valid link	The UIP160P cannot detect a valid link.	The UIP160P is receiving data on its
	on its WAN port.		WAN port.
Phone	The telephone connected to this	The connected phone is on hook (not in use).	Fast: There is an incoming call.
	port is in use or off hook.		Slow: There is a message waiting.

While the UIP160P is downloading a firmware update or a new configuration file from Packet8, the LEDs will blink several times.

Resetting the UIP160P

There are two ways to reset the UIP160P: a power cycle restarts the unit, and a hard reset restores the unit to factory defaults.

Power Cycle

Simply unplug the telephone UIP160P and plug it in again. This restarts the UIP160P and reloads the configuration file.

Hard Reset

A hard reset restores the UIP160P to factory defaults. All configuration changes will be lost.

A:Unplug the UIP160P's AC adapter.

B:Insert a pin or bent-out paper clip into the RESET hole on the rear of the UIP160P and push the reset button.

C:While holding the reset button pushed in, reconnect the UIP160P's AC adapter.

D:Hold the reset button for ten seconds and then release it. This sets the UIP160P main base back to factory defaults.

w w w . u n i d e n . c o m T R O U B L E S H O O T I N G [ 5 8 ]

T R O U B L E S H O O T I N G