Reading the LED Status, Attaching the Belt Clip, State

Reading the LED Status

The illustration below points out the location of the LED indicators.

This table explains the LED indicator status. For the exact locations of the on/off button, feed button and the AC adapter port, refer to “A Tour of the MP200” on page 8.

LED Indicator	State	Status
LED 1		Low Power Mode
	Purple or Orange	(In Bluetooth mode the LED is
		purple. In RS232 mode the LED
		is orange).
	Green	Indicates that power is on and
		that the printer is in RS232 or
		IrDA mode.
	Blue	Indicates that power is on and
		that the printer is in Bluetooth
		mode.
LED 2	Yellow	The battery charger is charging
		the battery at a fast rate. If the
		battery is below 5V, the battery is
		being “trickle-charged” until the
		battery voltage reaches 5V, and
		then the fast-charge rate starts.
		The LED will turn off when the
		battery is fully charged.
LED 3	Green	Indicates that the MSR is ready
		to accept data.
	Red	Indicates a fault condition or a
		printer error, and the printer is
		not ready to accept data.
		The printer is out-of-paper.

Attaching the Belt Clip

The belt loop system consists of two parts:

•A knob located on the back part of the printer just above the battery door.

•A strap with a click-on connector.

To attach the strap to the knob, insert the knob located at the bottom of the printer into the slot on the connector. Pull down until you hear a click. The printer is now secure. Place the loop over your belt. Allow the printer to hang down on the left or right hip.

•To release the printer, press down on the two latches on the connector, and pull the knob clear of the slot.

Knob

		Release Latches
Connection		Release Latches
Connection

NOTE: Do not force or pull the printer from the connector without pressing down on the two latches.

Unitech MP200 manual Reading the LED Status, Attaching the Belt Clip, LED Indicator, State

Models: MP200

Reading the LED Status

LED Indicator

State

Status

Attaching the Belt Clip