United States Stove 2827 owner manual Locating The Heater, Description

LOCATING THE HEATER

AS A LOCATION IS SELECTED, KEEP THE FOLLOWING IN MIND:

1.The chimney connection should be as possible. The heater must have its own chim- ney. Do not connect this unit to a chimney flue, serving another appliance. If there is no chim- ney near where you wish to place the heater, you can use a UL 103HT Residential Type and Building Heating Appliance Chimney (Fig. 5 &6).

NOTE: BEFORE FIRING

HEATER

Slide firebricks toward the rear

so no gaps remain between

them.

REPAIR PARTS LIST - MODEL 2827 (SEE PAGE 18)

AUTOMATIC COAL BURNING CIRCULATOR

		Key No.	Description	Qty.	Part No.
1			Shaker	1	40045
	2		Second Heat Shield Assembly	1	22030
3			Heat Shield	1	22110
4			Draft Damper Hinge Pin	1	17200
5			Draft Damper Frame	1	40075
*			1/4-20 x 3/4 MS	4	83086
*			1/4-20 Kep Nut	4	83250
		6	Base	1	67859
7			Draft Control Damper	1	67132

2.Place the heater on solid masonry or solid concrete. When the heater is used on a com- bustible floor protector of one layer of 3/8" millboard having a thermal conductivity of K=0.84 BTU in./ft. 2 hr. Deg. F with 28-gauge sheet metal or a UL Listed floor protector. Have the floor protector extend 16" beyond the door side of the heater and under the connector pipe in the back.

3.Check Figures 2, 3, and 4. Be sure you have the clearances shown from the heater and the connector pipe to combustible surfaces. If you have a solid brick or stone wall behind your heater, you can place the heater as close as you wish to the wall. If the wall is only faced with brick or stone, treat it as a combustible wall.

CAUTION:

Keep furnishings and other combustible materials away from the heater.

8	Clip	1	83818
9	Coal Grate	1	40101
10	Grate Support	2	22536
*	1/4-20 x 3/4 MS	8	83086
*	Nut 1/4-20 Kep	8	83250
11	Firebrick	10	89066
12	Firebox	1	67858
13	Front & Back Liner	3	40100
14	Flue Collar	1	40246
15	Flue Collar Gasket	1	88032
16	Firebrick Retainer	2	40132
*	1/4-20 x 1	6	83227
*	1/4-20 Kep Nut	6	83250
*	Smoke Curtain Bracket	2	22171
*	1/4-20 Kep Nut	2	83250
*	Machine Screw (1/4-20 x 3/4 PH)	2	83086
17	Hinge Pin	1	83872

	26"
Fig. 2			25"
	WONDERCOAL		Fig. 3
			35"
		16"	12"

54"	NON-COMBUSTIBLE
	CONSTRUCTION IN
	ACCORDANCE WITH
12"	NFPA 211

Fig. 4		36"
		19 1/4"
		NOTE: DASHED LINES SHOW
		STRAIGHT UP AND THROUGH
		THE WALL INSTALLATION
32 1/4"	16"	4 3/4"
17"

SIDEWALL FLOOR PROTECTOR (TOP VIEW)

18		Smoke Curtain	1	22090
	19	Coal Grate Frame	1	40102
20		Feed Door Assembly	1	68605
21		1/4-20 Kep Nut	2	83250
22		Draft Wheel	1	40056
23		Machine Screw (1/4-20 x 1)	1	83227
	24	Door Handle	2	40091
25		Wood Handle	1	89523
26		Feed Door Rope Gasket	45"	88033
27		Ash Door Assembly	1	67781
28		Two-Step Latch	1	22434
29		Washer, Flat	2	83045
30		1/4-20 Kep Nut	2	83250
31		Ash Door Gasket	29"	88033
32		Latch	1	22108
33		Ash Pan	1	67444
*		1/4-20 x 3/4 MS, SL, FL,2	6	83086
*		1/4-20 Kep Nut	6	83250
34		Latch Spacer	1	21467
35		Hinge Pin (Long)	1	83114
*		NOT SHOWN

4 17