United States Stove 2941 F36 BLOWER KIT, Tools And Material Needed, Circulator Dimensions

TOOLS AND MATERIAL NEEDED

TOOLS	MATERIALS
Pencil	Chimney Connection- 6" Dia. Black
6 Foot Folding rule or tape	Steel (24 Ga. minimum): Straight or
Tin Snips	corrugated elbow (as required)*
Drill, hand or electric	1/2" Sheet Metal Screws
Drill bit, 1/8" dia.	6" Inside Diameter Underwriters
(for sheet metal screws)	Laboratories (UL) listed Residential
Gloves	Type and Building Heating Appliance
Screwdriver (blade-type)	Chimney, Type "HT", or 6" existing
5/16" Nut Driver or	Masonry Chimney with flue liner.
5/16" Socket w/Ratchet	Floor Protector Material: 3' x 4'-6" as
	specified on page 4.
	Furnace Cement (Manufacturer
	recommends: Rutland Code 78 or
	Equivalent)
	* Avoid adjustable elbows, they leak!

CIRCULATOR DIMENSIONS

Fig. 1

	32 1/4	19 1/4	4 1/4
12 1/2	CENTER LINE OF 6"		CENTER LINE
	CHIMNEY CONNECTOR
			OF 6"
			CHIMNEY
	WONDERWOOD		CONNECTOR

33 1/2

24

4 1/8

TOP OF FLOOR PROTECTOR

RULES FOR SAFE INSTALLATION AND OPERATION

Read these rules and the instructions carefully.

SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For your safety, follow the installation directions. Contact local building or fire officials about restrictions and installation inspection requirements in your area.

F36 BLOWER KIT

An Optional Blower kit is available for the 2941 Wonderwood automatic wood burning circulator heater. If this kit is not available where you have purchased this Wonderwood heater, you can purchase the F36 Blower Kit directly from the factory. To order contact the United States Stove Company at the address and telephone number given on the back page.

1.Check local codes. The installation must comply with their rulings. Do not install this heater in a mobile home or trailer.

2.Always connect this heater to a chimney or vent to the outside. Never vent to another room or inside a building.

3.Do not connect a WOOD burning heater to an aluminum Type B gas vent. This is not safe and is prohibited by all codes. This

heater requires connection to approved chimneys: Either a factory built 6" UL 103HT or a lined and approved and recently in spected and cleaned masonry chimney with a 6" flue, preferably round. A larger masonry flue may be used, so long as the flue-section diameter is not greater than 50 sq. in.

The chimney portion (whether factory-built

2 19