6039I ASSEMBLY
DISCONNECT THE POWER CORD BEFORE SERVICING THIS STOVE
|
| (a) |
| (b) | (a) |
|
| |
(e) |
| (c) |
|
| |
|
| (h) |
| (f) |
|
| (g) |
|
|
| (i) |
|
| (j) |
(d) |
|
|
(k) |
|
|
4 |
|
|
For the following assemblies, we suggest locating the unit near it’s desired location. Depending on installation, you may want to connect the exhaust venting before installing the facade parts.
Assembly - Facade (Surround)
Remove contents from packaging and make sure you have all components:
(2) Top Facade (a)
(1)Left Side Facade (b)
(1)Right Side Facade (c)
(4 pieces)Facade Trim Kit (d)
(1)Feed Door Spring Handle (e)
(1)Damper Spring Handle (f)
(1)Ash Pan “U” shaped Handle (g)
(1)Access Door Knob (h)
(1)PCB Cover (i)
(1)Panel Cover (j)
(1)Auger (in ash pan)
(1)Power Cord
(1)Burnpot Poker (k) Mounting Hardware
Start by mounting either the left or right side facade pieces to the unit using four(4) of the supplied #10 x 1/2 screws. Then put the two(2) top facade pieces together with two(2) of the #10 x 1/2 screws provided. Attach the top facade assembly to the unit with eight(8) of the same screws.
Control Board (PCB) Re-location
Remove the left side front panel from the unit. While holding the PCB with one hand, remove the two(2) hex head screws holding the board in place. It is not necessary to unplug the PCB cable. Route the board and cable through the opening and mount it to the Left Facade using two of the #10 x 1/2 phillips head screws provided. Then attach the PCB cover to the back of the facade covering the board. Next, use the two hex head screws removed earlier and mount the cover panel over the opening where the PCB was located. See illustration to the left.
Facade Trim
Remove trim from shipping tube. There should be one(1) left side, one(1) right side, two(2) top pieces, and mounting hard- ware. Using one blank corner key and one corner key with set screws, assemble the left trim and one of the top pieces to- gether. As illustrated, place the blank key behind the key with the set screws. Adjust corners and tighten set screws. Repeat this for the right side
Before removing tape, place trim assembly against facade to get an idea of how it is to be mounted. Remove the strip from the adhesive and carefully secure the trim in place by firmly pressing it to the facade.
Burnpot Poker
The burnpot poker may be used serveral ways. It is used pri- marily as a
USSC
